• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

When a full lever replacement is needed, the fitting type has to match what is already there. Side levers, which mount through a hole in the side of the cistern, come in different thread diameters and in both metal and plastic bodies, and the arm length inside the tank needs to reach the flush valve or siphon without fouling the tank wall. Levers that mount through the lid, more common on close-coupled and concealed designs, connect via a spindle rather than a side arm and are not interchangeable with side-lever fittings.

Before ordering, it helps to note the frame's brand if it is visible on the tank or access panel, along with the fill valve and flush valve dimensions if the old parts can be measured before removal. Plumb2U stocks fill valves, flush valves, cables, https://www.instagram.com/plumb2u/ spindles and flush plates suited to the concealed cisterns most commonly found in UK homes, at trade prices, which helps when a plumber is working blind on a job where the tank itself cannot be seen until the access plate is off. With next-day despatch available on the common models, Plumb2U's stock list is worth checking against the frame details before committing to a specific part.

The lever type matters too. Close-coupled cisterns almost always use a side lever or a push button through the lid, while older low-level suites more often run a side lever connected by an external link arm. Ordering a replacement lever without checking which type is fitted is a common cause of parts being sent back.

A cistern that whistles, knocks or hammers while filling is one of the more annoying faults a customer will report, and it is also one of the quicker ones to run down with a short checklist before a plumber even gets to the van. Two causes account for the large majority of noisy-cistern callouts: a worn fill valve and excessive mains pressure, and telling them apart early saves time on site.

For more detail, see plumbing spares supplier.

Noise is a real factor when deciding between the two. A side-entry valve introducing water above the surface tends to produce more splash and a higher-pitched fill sound, which shows up as a complaint on quieter properties such as flats with shared walls. Bottom-entry valves that fill below the surface are noticeably quieter, and swapping a noisy side-entry unit for a bottom-entry equivalent is a common upgrade even where nothing has technically failed.